<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: Alarms

The alarms list shows all sensors that are in the Down, Down (Partial), Down (Acknowledged), Warning, or Unusual status. Sensors in the Up, Paused, or Unknown states do not appear here.

By default, table lists that show alarms are sorted by priority.Click a column header to sort the list items by a different category.

There are two ways to display the alarms list. Either click the Alarms tab of a probe, group, or device, or click Alarms in the main menu bar.

Alarms (Object Tab)

Probe, group, device, and sensor pages have tabs that you can use to navigate between the different options. For example, you can view your network's status, view monitoring results, or change settings.

Click the Alarms tab of a probe, group, or device to show a table list of all sensors on the selected object that show the Down, Down (Partial), Down (Acknowledged), Warning, or Unusual status. This list is a subset of the entries that are available via the Alarms | All option in the main menu bar.

The Alarms tab is not available for sensors.

Alarms (Main Menu Bar)

Click Alarms in the main menu bar to show a table list of all sensors in your installation that show the Down, Down (Partial), Down (Acknowledged), Warning, or Unusual status. You can also show these sensors as gauges or only show a subset of sensors in specific states. Hover over Alarms to show further options:

Acknowledge Alarm

An acknowledged alarm shows the Down (Acknowledged) status. It does not trigger any more notifications.

If the alarm condition clears, the sensor usually returns to the Up status with the next sensor scan.

If a sensor in the Down (Acknowledged) status was paused and resumed, it shows the Down status again.

To acknowledge an alarm, right-click a sensor that shows the Down status. From the context menu, select Acknowledge Alarm, then select a time span, optionally enter a message, and click OK. The message appears in the last message value of the sensor.

The time spans that you can select are: Acknowledge Indefinitely, acknowledge For 5 Minutes, For 15 Minutes, For 1 Hour, For 3 Hours, For 1 Day, or Until. If you select Until, provide the following information:

By default, only read/write users or administrators may acknowledge alarms. However, you can give read-only users the right to acknowledge alarms, too. See the system administration settings, section User Accounts.

More

Knowledge Base

Which audible notifications are available in the PRTG web interface and in PRTG Desktop?

• https://kb.paessler.com/en/topic/26303