<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: SNMP NetApp I/O Sensor

Sensor Name

Enter a name to identify the sensor.

Parent Tags

Shows tags that the sensor inherits from its parent device, parent group, and parent probe.

This setting is for your information only. You cannot change it.

Tags

Enter one or more tags. Confirm each tag with the Spacebar key, a comma, or the Enter key. You can use tags to group objects and use tag-filtered views later on. Tags are not case-sensitive. Tags are automatically inherited.

It is not possible to enter tags with a leading plus (+) or minus (-) sign, nor tags with parentheses (()) or angle brackets (<>).

For performance reasons, it can take some minutes until you can filter for new tags that you added.

The sensor has the following default tags that are automatically predefined in the sensor's settings when you add the sensor:

• snmpnetappiosensor
• snmpnetapp
• netapp

Priority

Select a priority for the sensor. This setting determines the position of the sensor in lists. The highest priority is at the top of a list. Choose from the lowest priority () to the highest priority ().

Primary Channel

Select a channel from the list to define it as the primary channel. In the device tree, the last value of the primary channel is always displayed below the sensor's name. The available options depend on what channels are available for this sensor.

You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab.

Graph Type

Define how different channels are shown for this sensor:

• Show channels independently (default): Show a graph for each channel.
• Stack channels on top of each other: Stack channels on top of each other to create a multi-channel graph. This generates a graph that visualizes the different components of your total traffic.
  You cannot use this option in combination with manual Vertical Axis Scaling (available in the channel settings).

Stack Unit

This setting is only visible if you enable Stack channels on top of each other as Graph Type. Select a unit from the list. All channels with this unit are stacked on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so.

CIFS Ops

The number of Common Internet File System (CIFS) operations per second

Disk Read

The disk read speed in bytes per second

Downtime

In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down status in percent.

Disk Write

The disk write speed in bytes per second

FCP Ops

The number of Fibre Channel Protocol (FCP) operations per second

FCP Read

The FCP read speed in bytes per second

This channel is the primary channel by default.

FCP Write

The FCP write speed in bytes per second

HTTP Ops

The number of HTTP operations per second

ISCSI Ops

The number of Internet Small Computer System Interface (iSCSI) operations per second

ISCSI Read

The iSCSI read speed in bytes per second

ISCSI Write

The iSCSI read speed in bytes per second

Network Received

The number of bytes received per second

Network Sent

The number of bytes sent per second

NFS Ops

The network file system (NFS) operations per second

Tape Read

The tape read speed in bytes per second

Tape Write

The tape write speed in bytes per second